Lefant Nautica Hard Eco Black 2,5L

Nautica Hard Eco on uusi ja innovatiivinen lisäys Lefantin

biosidivapaiden pohjavärien valikoimaan, joka sopii purje- ja moottoriveneisiin kaikilla nopeusluokilla. Korvaa TF ja Mark5.

Vähentää kitkaa ja lisää nopeutta sekä vähentää polttoaineen

kulutusta. Suojaa venettä likaantumiselta ja antaa pinnan, joka on helppo pitää puhtaana.

Soveltuu ja on turvallinen käyttää myös alumiinirungoilla,

ja sitä voidaan levittää suoraan monenlaisiin olemassa oleviin

pinnoitteisiin.

Yhteensopivuus: Lefant Mark 5, TF, Nautica Copper ja useimmat

muut kovat ja puolikovat liuotinpohjaiset pohjavärit.

Väri: Musta

Riittoisuus: 13m²/litra

Viimeistely: Matta

Kiintoainepitoisuus: 50 ±2% (ASTM D2369).

Leimahduspiste: 30°C

Ominaispaino: 1,44 (ISO 2811-1).

VOC: 430 g/l (ISO 11890-2/2006).

Yksikkökoko: 2500 ml

PRODUCT DATA

Colors: Dark Blue, Black

Coverage: 13m²/liter

Finish: Matte

Compatibility: Direct over Lefant Mark 5, TF, Nautica Copper and most of other hard and semi hard solventbased antifoulings.

Volume Solids: 50 ±2% (ASTM D2369)

Flash Point: 30°C

Specific Gravity: 1,44 (ISO 2811-1)

Shelf Life: 2 years (min)

VOC: 430g/l (ISO 11890-2/2006)

Unit Size: 750ml, 2500ml

APPLICATION DATA

Application: Brush, Roller

Coverage: 13m²/liter

Film Thickness: 40-60µ (dry)

Number of Coats: 2 coats for seasonal protection. Extra coats in areas where the fricton and wear are higher, such as rudder, stem, waterline.

APPLICATION INTERVAL

Temperature - 10°C Min - 20°C Min/Max

Overcoating - 10h - 6h

Launching - 24h - 12h/2 mth.

Conditions during application: Do not paint in wet or humid conditions. The substrate temperature should not understep +5°C during the application and 6 hours after the job is done. Drying times and overcoating intervals will increase with thicker paint layers. When applying in confined spaces, make sure the area is sufficiently ventilated.

SURFACE PREPARATIONS

Surface in good condition: Remove all traces of loose paint and contamination by sanding the entire surface well with 80 grit sandpaper. Remove sanding debris.

Surface in poor condition: Completely remove all old antifouling paint using Lefant Paint Remover or by sanding or sandblasting to near base surface.

Surface of BARE Gelcoat/GRP: It is very important that bare gelcoat/GRP be properly prepared. Remove mold release wax using Lefant Boat Cleaner concentrated followed by using Lefant IPA Surface Cleaner.

Sand the surface rough (grit 80)and fill any surface imperfections with

Lefant Epoxi Filler following the label instructions. Apply at least one layer of Lefant Epoxi Primer by following label instruction.